Kbase 5463: insufficient dynamic memory
| Autor |
Progress Software Corporation - Progress |
| Acesso |
Público |
| Publicação |
10/05/1998 |
|
insufficient dynamic memory
900822-pmf01
Date Last Modified: 10/09/90
INTRODUCTION:
=============
This Technical Support Knowledgebase entry explains what to do if you
receive the VMS error "Insufficient Dynamic Memory" while installing
PROGRESS on a VMS-based system.
PROGRESS ERROR NUMBER: ERROR TEXT: ERROR TYPE:
====================== =========== ===========
None INSFMEM: insufficient VMS
dynamic memory.
POSSIBLE CAUSE OF ERROR:
========================
A VMS system parameter, most likely the number of control pages, global
pages or dynamic pages needs to be increased.
DOES ERROR INDICATE CORRUPTION: IF SO, WHAT TYPE:
=============================== =================
No N/A
CORRECTIVE MEASURES:
====================
There are three areas to check when you receive this error. They are
ordered below based in their likelihood of causing the problem.
1. Check the VMS parameter CTLPAGES ( Control Pages ). The system
default is 50. PROGRESS needs at least 120 control pages.
2. Check the VMS parameter GBLPAGES (Global Pages). PROGRESS
requires that at least 1670 global pages be specified.
3. Check the VMS parameter NPAGEDYN (Number of Dynamic Pages). If
you're sure that CTLPAGES and GBLPAGES are set high enough (as
required in steps one and two above), then increase NPAGEDYN.
ONLINE PROCEDURES OR UTILITIES:
===============================
VMS System Administrators Functions
REFERENCES TO WRITTEN DOCUMENTATION:
====================================
PROGRESS VMS Installation Guide.
VMS Volume 6a System Messages page 2-265.
Progress Software Technical Support Note # 5463