Kbase 17483: Duplex printing in Results
| Autor |
Progress Software Corporation - Progress |
| Acesso |
Público |
| Publicação |
10/05/1998 |
|
Duplex printing in Results
DRAFT COPY - Currently under review and edit.
INTRODUCTION:
=============
This KBase describes how to enable "duplex" printing in
CHARACTER Results
WHY YOU NEED TO KNOW THIS:
===========================
In Results it could be difficult to have the printer understood that
the 2nd page to be printed should end up on the back side of the
paper instead of on the 2nd piece of paper in order to safe paper and
the environment.
PROCEDURAL APPROACH:
====================
In Results, under the Admin module -> Printer Settings - Control
Sequences, you will be enabled to enter the control sequences needed
to have your printer understand that the 2nd page ends up on the back
side of the paper.
When you just enter all the sequences needed you will see that in some
cases the printer does NOT print in "duplex"-mode. Therefore you need
to add a Carriage Return-code at the end of the entire string in order
to have your printer understand the commands correctly.
ONLINE PROCEDURES OR UTILITIES:
===============================
REFERENCES TO WRITTEN DOCUMENTATION:
====================================
KBase: #16439 - How to turn on/off duplex printing in GUI Results
Specific Printer Manual(s)
Author: mhu, December 12, 1997 - 22:09 (GMT +1)
Progress Software Technical Support Note # 17483